|
Part #: 00036
I don't remember where I originally picked this up, I think it was a giveaway at some off road show I was at. It pretty much sat forgotten in the bottom of my center console for a few years. I was running some trails with a friend who was camping and had disconnected his trailer and removed his hitch. As you have already guessed the pin was nowhere to be found when we were ready to leave the area. Digging around the vehicles to try and find some type of pin to hold the trailer hitch in I rediscoverd the Factor 55 hitch pin in my console. Pin installed and off we went back to civilization. The pin actually stayed installed in his rig for about 6 months before he remembered it and returned it to me. I figured the pin would show some wear from being in the hitch and having a trailer hooked to it for most of those 6 months. The only signs of wear on the pin are some slight scuff marks from the trailer hitch and receiver exert most of their force against the pin.
The Factor 55 Quick Release Hitch Pin for 2 to 2.5" Hitch Receivers is made of a high strength stainless steel. The quick release part is not really any different than other hitch pins that use a safety pin to hold them in place. I does boast a 50,000+ shear strength and is made in the USA. One side is drilled for the safety pin to be installed and the other side has a machined grove so you can get your fingers around it to remove it from the hitch. While this makes the pin sleak and stylish, you really can not get your fingers around it if you are wearing gloves.
Specifications:
Additional
Parts: |
Tools
Needed: |
|
Factor 55 Phone: (833) 727-8784 Customer Service |
N-m | Ft. Lbs. | In. Lbs. | |
This page last updated: 19-Feb-2024
Content
and Design © 2002-present WanderingTrail, Ronald Seegert
Common Sense and Safety should always be observed when working on your vehicle or doing modifications. Jackstands, wheel blocks, disconnecting the battery are a few of the basic safety precautions that should be used and may not be mentioned in the write ups on this site. You are responsible for your own installation, these write ups are a helpful guideline and should not be taken as an official installation instruction. My write up may be different from the kits currently out there, so alwasy double check the manufacturers installation instructions when installing anything. I try to keep the site up to date with changes that have occured as I discover them, but may not have the latest unless someone lets me know. If you feel that an install is above your capabilities after reading my write ups, I recommend getting together with a club and getting some help. Only a few times have I needed to employe some actual help from a shop to get something done. Usually welding or A/C work. While I have spent many years working on mechanical systems, I am not an expert, nor do I pretend to be one. I hope these write ups have been useful to you.
All trademarked names & logos are property of their respective owners
This site is in no way associated with FCA.
Jeep is a registered trademark of FCA.